The HP Sticky Shield is a way to stop heat from radiating into the compartment of your ride.
Made from a layer of 1/8" fiberglass insulation shielded by a layer of .003" thick aluminum, HP Sticky Shield is resistant to the elements and may be cleaned after installation.
The heavy duty adhesive will bond to almost any clean surface (not recommended for unfinished fiberglass or carbon).
It is the radiant heat shield perfect for transmission tunnels, mufflers, catalytic converters, DPF's, turbo, downpipes, and exhaust system heat.
This HP Sticky Shield can be used with less than 1" of airspace; however, when used with 1" or more airspace, it is capable of shielding over 90 percent of heat.
Did that set of long tube headers on your Mustang, Camaro, Challenger, or tuner move your catalytic converter where there are no factory heat shields?
Use Sticky Shield to stop the heat!
That Jeep getting serious heat in the transmission tunnel or from the cat, Sticky Shield it away!
HP Sticky Shield is asbestos free.
This product is designed to be used UNDER the vehicle on the floor pan, firewall, transmission tunnel, etc., and is not designed to be used under the carpet.
Use Heatshield Armor Weld Tape to seal seams when putting two of these heat shields together and also protect the edges of HP Sticky Shield.
You can even use the weld tape to repair any damage caused to HP Sticky Shield from on or off road hazards.
Please note, this product ships folded or rolled to keep costs down.
You may see bends in it when it is received; bends will become minimally visible after installation.
Installation tips: Self Adhesive and Radiant heat barrier, requires 1 Inch of airspace.
Not designed for direct contact.
